- 28 -
HDTV 1000 T / HDTV 1001 T
—>
Ê Ê>``ÌÊÌÊÌ iÊ`V>ÌÀÊÊÌ iÊ`ë>Þ]ÊÌ iÀiÊÃÊ>ÃÊ>ÊÃÌ>ÌÕÃÊÊÜ V Ê
indicates the quality of the received transport stream:
LED indicator
Indication
Green
Signal quality is good
Yellow
Signal quality is poor
Red
No signal
Off
The channel strip (modulator)
is switched off
Ê
UÊ *ÀiÃÃÊÌ iÊ
button to return to the main menu.
If the input signal path “
A+B+ASI=1 ASI=2
” is selected the station filter of
channel strip “
B
” is used in the channel strip “
A
”. Therefore perform the settings
for channel strip “
B
»Ê ÊÃV>ÌÀÊvÀiµÕiVÞ]Ê«ÕÌÊÃÞLÊÀ>Ìi]Ê6 Ê`i]Ê
«ÕÌÊvÀiµÕiVÞ®Ê>VVÀ`}ÊÌÊÌ iÊ«>}iÃÊÓxÓÇ]ÊLivÀiÊ>VÌÛ>Ì}ÊÌ iʺ-iÌÌ}Ê
the station filter” – “
PROGRAM
” menu.
If the input signal path “
A+ASI=1 B+ASI=2
” is selected the channel strips can
be programmed one after the other.
Ê
UÊ *ÀiÃÃÊÌ iÊ
button.
—> The “Setting the station filter” – “
PROGRAM
” menu is activated.
Setting the station filter
The default setting for the station filter is “
off
”. In this menu you define the sta-
tions received to be transmitted. If stations are activated the output data rate
increases.
If the station filter is switched off (factory default) all stations of the transport
stream passes the station filter. As soon as the station filter is activated all sta-
tions are inactive and can be added to the transport stream selectively.
The figure of the menu below is dependent on the setting of the “Selecting the
input signal path” menu (page 21).
Status LED
Channel strip "A"
Status LED
Channel strip "B"
