- 28 -
HDTV 1000 TD
• Use the
button to place the cursor under "
DVB-S
" and set the required
DVB-S2-mode with the buttons
.
• Press the
button.
—> The "Input frequency" – "
FREQ
" menu is activated.
i
nPut
frequenCy
If three dots "
…
" appear in the second line of the display, the cassette is in
the "
station search
" mode. Please wait until the process has finished.
Once the RF receiver has synchronised to the input signal, any offset to the
target frequency is displayed in MHz, e.g. "
– 1.8
".
If a question mark "
?
" appears in the second line of the display, there is no
input signal present. In this case check the configuration of the antenna system
and head-end station as well as the preceding settings of the cassette.
Bx 4A
/B
11836 -1.8
FREQ
CN 12
Bx 4A
/B
12.0 dB
C/N
(+ 9.6) OK
• Use
to position the cursor under the digit of the frequency displayed
to be set.
• Press
to set the respective digit of the input frequency needed.
• Repeat the procedure by the quantity of the digits to be set.
• Set the frequency offset shown in the display (e.g. "
– 1.8
") to less than
1 MHz by varying the input frequency using the
buttons.
• Press the
button.
—> The "Signal to noise ratio" – "
C/N
" menu is activated.
