INC
DEC
23
If you turn on safety timer, safety timer will start timing
when charging.If system fault or system can’t identify
battery capacity already full, this safety time set can stop
battery being over charged. The safety time should not
shorter than the time battery fully charged, usually from
10min to 720min.
Safety time setting
Capacity cut-off program set the maximum charging
capacity. If safety timer stopped work or system can’t detect
the peak voltage, this program will stop charging/ discharg-
ing automatically if you’ve set the maximum charging
capacity, range from 10mAh to 50000mAh. .
Capacity cut-off program
Sound setting
DC input power is 19-26V, the program set the lowest cut-off
input voltage value is 19-26V. If the voltage lower than the
setting voltage level, procedure will be forced to end to
protect input power.
Input Power low cut-off
Resume to the default setting
Load factory set
This is used to check product version
Product version
INC
DEC
Safety Timer
ON 300min
INC
DEC
Capacity Cut-Off
ON 10000mAh
INC
DEC
INC
DEC
Beep sound on/off; Buzzer sound on/off.
Input Power Low
Cut-Off 18.0V
INC
DEC
Load Factory Set
Enter
Key Beep ON
Buzzer ON
Product Version
V1.1.1
Summary of Contents for X2mini
Page 16: ......
