Tiny vibration
Cavitation
Debris come off
Generator
Transducer
SUS304
TANK
Solution
Ultrasonic cleaning is based on
the cavitation effect caused by
high frequency ultrasonic wave
vibration signal in the fluid.
Microscopic bubbles are formed,
a n d t h e y i m p l o d e v i o l e n t l y
c a u s i n g t h e c av i t a t i o n w h i c h
c r e a t e a n i n t e n s e s c r u b b i n g
action on the surface of the item
being cleaned.The bubbles are
small enough to penetrate
microscopic crevices,cleaning
them thoroughly and consistently.
Ultrasonic cleaning is extremely effective at removing dirt
a n d g r i m e w h i c h w o u l d n o r m a l l y r e q u i r e t e d i o u s m a n u a l
c l e a n i n g b y h a n d . I t h a s b e e n u s e d t o c l e a n a w i d e va r i e ty
o f i n s t r u m e n t s a n d m e c h a n i c a l p a r t s s u c h a s c a r b u re t o r s ,
returning them to almost “like new” condition without
damage
to delicate parts.
Ultrasonic Cleaning Priciple
Detergent
ULTRASONIC PRINCIPLE
a: Lid
b: Control Panel
c:
: Housing
e: Power Cord
: Basket
d
Contents:
01
06
Press
“ ” button,heater is turned on,the indicator light
blue,press
“ ” button again to stop heating,indicator
07)
the
turn
the
light turn off.
08) When cleaning is completed,unplug the power cord,remove the
l i d a n d re t r i e ve t h e i t e m s , Po u r t h e wa t e r o u t t h ro u g h t h e
pouring recess.Clean and wipe the tank.
0 3 ) C l o s e t h e l i d p l u g m a c h i n e i n t o p o w e r o u t l e t p r e s s t h e
,
.
button to start machine
“
”
.
When the water temperature reaches 60
±
3
℃
overheat protect indicator
,
light turn red the heater will turn off automatically.when the water
,
temperature below 55
±
2
℃
heater will start to work automatically.
,
Adjust the timer according to the demand of
cleaning items.
VGT-6250
a
b
f
f
Power Socket
e
d
c
06) Timer Setting.
Press the “
” button to set timer,LED display
shows “
090
”,
press it again to set it to “
” the next each
180
.
pressing make it
to increase by100 seconds.
05) Select
“
” to start degas mode Intermittent
the
,
operation
ultrasonic power for rapid removal of
of
entrained air
from liquids,
ultrasonic work 5 seconds
and stop 2
seconds. the indicator
light turn green and flashing.Same cycle proceed.Press the
“
”
button again to stop it,indicator light(green) turn off.
04) Press
“
” button to start ultrasonic.the
the
indicator light
press
“
” again
the ULTRASONIC
turn green, to stop ultrasonic,
light turn off
the indicator
.
