User Manual
7100 Low Flyer
-I
GTM- 7100-MAN-001 (2) Page 5 of 11
Special care is required for
installation and adjustment of
your
7100-
Low Flyer I Hand Rim.
Take careful note of the points
below. If you do not, this may result
in
serious injury and/or death.
For your safety, only an authorized
dealer should install, adjust, or
service the hand rim.
You must register your hand rims
to make a warranty claim (see the
instructions in the Warranty
Section).
Ensure that you have done the
“Adaption Exercises”.
Only use your hand rim if it is
correctly and securely fitted.
Adhere to all instructions for
attaching the hand rim to the
wheel. Incorrect fitting could
cause the hand rim to fail and void
the warranty. Do not exceed 8-12
Nm torque for the attachment
bolts.
Always replace the self-locking
nuts once removed.
At
high
speed,
or
when
descending down a hill, be aware
that the
7100
hand rim will heat
your hand faster than a metal
hand rim. Adjust your speed and
approach accordingly.
The carbon composite black
surface can get hot when exposed
to direct sunlight. Check and allow
to cool down before using.
Do not exceed 170°F (77°C)
exposure to your hand rims. High
temperatures can occur inside an
automobile or exposure to an
open flame or other heat sources,
which may damage the adhesive
that holds carbon fibers together.
Watch for hazards while riding,
such
as
potholes,
sharp
protrusions, and various obstacles.
These hazards can damage hand
rim.
Any form of crack, puncture,
delamination, unusual noise, or
change of coloring indicates that
the hand rim maybe unsafe to use.
Stop
using
the
hand
rim
immediately and consult your
authorized dealer.
Impact or crash damage to
composite hand rim may be
invisible to the user. Consult your
authorized dealer immediately.
Do not use pressurized water for
cleaning.
Do not use solvents to clean, only
wash with warm soapy water.
Do not use any other material than
Stainless Steel for the attachment
bolts, washers, and nuts to prevent
corrosion.
WARNING
Safety Instructions
