2
Thank you for choosing our Hydraulic Furniture Mover.
All information contained within this manual is based on
data available at time of creating. we reserve the right to
modify the product at any time without notice or incurring
any sanction. Please contact GT for any possible updates.
SPECIFICATIONS
APPLICATION
The Manual Furniture Mover has been developed for
the lifting and transporting of cabinets and other large
regular objects. For this reason, it’s supports are lined with
foam rubber to prevent the goods being transported from
becoming damaged.
Since the Hydraulic Furniture Mover consists of two units,
rectangular objects of varying length can be moved using
a minimum of space. Due to the weight of the steel cabinet
on the platform, it will hold itself in position when the units
are standing vertically and the frame of the platform is in
contact with it’s sides. The securing strap, which has to
be fastened correctly on both sides, is an additional and
absolute necessity. The steering handles have a full lock
of 180°, this means that goods being transported may
be moved in every direction. The platforms are raised
by operating the lever of the pump; this lever must not
be used for pulling or pushing the BIMOBIL. The goods
transported are lowered by twisted the manual release
valve on the compact hydraulic system to the left.
Great care must be taken when lowering the platform,
since the speed depends on the valve, must be twisted
to the right until the stopper allows you to close it. Using
an old rate, try a few “dry runs” with the transport units
moving furniture with them. If you operate properly, our
Hydraulic Furniture Mover will help you to move cabinets,
furniture etc quickly and safely.
ASSEMBLY
Remove the fork pin at the free end of the track rod, set
the steering handles parallel to each other, and push the
fork of the track rod over the arm of the steering handle.
Then replace the previously removed fork pin through
the fork, arm and secure it with a clip. The second unit is
assembled in the same way.
PRECAUTIONS AND PREPARATION
The floor must be absolutely level, smooth and clean.
There must be no inclines or slopes to be moved over.
Make sure that the floor and the floor covering, are able
to stand up to the loading imposed by the wheel and
ensure they can take the weight of the furniture being
transported.
Check whether the piece of furniture to be transported
contains any loose objects. These will have to be
removed, or secured to stop them slipping out of position.
Check whether the piece of furniture is strong enough
for the two opposite sides to take the weight of the piece
via the transport units’ platforms, and whether the upper
supports of the transport units can hold the furniture to be
transported without damaging it.
Find the weight of the piece of furniture to be transported.
The maximum load of 1800 kg/pair = 900 kg for each unit
must not be exceeded.
Find the centre of gravity of the furniture to be transported.
Along the furniture base, it is decisive for the load that a
single transport unit can bear, across the base, the centre
of the transport unit, and, in connection with the height,
for the moment of tilting that occurs when moving the
furniture. When in use, the height of the centre of gravity
must not exceed 0.8m. The distance of the transport units
to one another must not be less than 0.5m and not exceed
4.0m.
Never use this equipment for towing behind a vehicle.
Safety Information
For your safety and correct
operation, please carefully
read the manual before use.
Part
No.
Capacity
kgs
Lifting
Height
mm
Lifting
Plate Size
mm
Weight
kgs
FM180B
1,800
100
600x60
86
