MIDI-IN Control Change
Setting up your REVPAD system for MIDI-IN Control Change allows you to use your MIDI device to turn REVPAD effects on or off
(bypass).
1.
Connect a cable from the MIDI-OUT port of your MIDI device to the MIDI-IN
connector in the back panel of the base unit and verify that the MIDI RX channel is
set correctly, according the requirements of your MIDI device.
for more information.
2.
Press the
SYS
button (
A
) four times. You will see the
MIDI-IN CC MAP
menu (
B
).
3.
Press the down arrow (
C
) to see the CC Map (
D
). The first effect, Distortion 1
(
DST-1
), is selected with the default value of Off.
4.
Rotate the Navigation Roller (
E
) to the command change number, from 0 to 127, of
the switch in your MIDI controller you wish to use to turn on and off ( bypass)
effects in the current patch of the REVPAD system.
Note:
If you do not know the switch values in the MIDI device, set the CC Map value to
LEARN
and then send the CC you wish to use to effect the control change. The REVPAD system will use the received CC number.
5.
When the command change has been set, press the right arrow (
E
) to select another effect to map.
Note:
You may use the same mapping value for more than one effect.
59
MIDI Control
Summary of Contents for REVPAD
