•
Select and Play
makes the MIDI patch selection immediately upon touching the desired segment and exits MIDI Program
Change.
4.
Next assign a MIDI Program Change layout to a Touchpad Control Button. Press
SYS
and then navigate to the Control Button
assignment screen in system configuration.
Touchpad Control Button Assignment
for more information.
MIDI-OUT Control Change
Setting up the REVPAD MIDI-OUT Control Changes allows you to send up to six different CC values using the Touchpad to external
MIDI devices.
1.
Connect a cable from the MIDI-OUT/Thru connector in the back
panel of the base unit to the MIDI-IN port of your MIDI device
and verify that the MIDI TX channel is set correctly, according
the requirements of your MIDI device.
for more information.
2.
Select a patch for which you want to add MIDI-OUT sittings.
for more information on this
procedure.
3.
Press the right arrow button (
A
) eight times until you see the
third effects screen (
B
).
4.
Press the right arrow button (
A
) twice more (
B
) to select
MIDI
.
5.
Press the down arrow (
C
) to see the MIDI Channel page (
E
). Rotate the Navigation Roller (
E
) to appropriate MIDI channel (CH-1
through CH-16). For this example CH-1 has been selected.
6.
Press the down arrow (
C
) to see
CC-1
, the first MIDI Control Change page (
F
). Rotate the Navigation Roller (
E
) to adjust values
according to the table below.
61
MIDI Control
Summary of Contents for REVPAD
