105
3. Oil tank
With a wire hook, take out the oil filter through the
filler port and clean in gasoline. When putting the
filter back into the tank, make sure that it comes to
the front right corner. Also clean off dirt in the tank.
(2) Oil filter
4. Spark plug
Clean the electrodes with a wire brush and reset the
gap to 0.65mm as necessary.
Spark plug type
：
NHSP LD L8RTF or CHAMPION RCJ7Y
or NGK BPMR7A
5. Sprocket
Check for cracks and for excessive wear interfering
with the chain drive. If the wearing is found
obviously, replace it with a new one. Never fit a new
chain on a worn sprocket, or a worn chain on a new
sprocket.
(1) Needle bearing
(2) Sprocket
(3) Clutch drum
(4) Washer
(5) Clutch block
6. Front and Rear dampers
Replace if adhered part is peeled or crack is
observed on the rubber part.
Summary of Contents for GTC56
