95
7
.
Operation
■
STARTING ENGINE
1. Untwist and remove the fuel cap and oil cap.
Rest two caps on a dustless place.
2. Put fuel and oil into the fuel tank and the oil
tank to 80% of the full capacity.
3. Fasten two caps securely and wipe up any fuel
spillage around the unit.
4. Put the switch to the "I" position.
5. Continuously push the priming bulb until fuel
comes in the bulb.
(1) Oil
(2) Fuel
(3) Engine switch
(4) Choke knob (5) Primer bulb
6.
Pull out the choke knob. The choke will close
and the throttle lever will then be set in the
starting position.
When restarting immediately after stopping the
engine. Set choke in the open position
Once the choke knob has been pulled out, it will
not return to the operating position even if you
press down on it with your finger. When you wish
to return the choke knob to the operating position,
operate the throttle trigger instead.
7. Push the
front handle guard
down toward the
front to activate the chain brake.
8. Push in the decompression valve button. (If
applicable)
9. While holding the saw unit securely on the
ground, pull the starter rope vigorously.
Summary of Contents for GTC56
