ii
GTO 2002XLS Instruction Manual © 01.12.12
Thank you for purchasing a GTO/ACCESS SYSTEMS 2002XLS. When correctly installed and
properly used, your 2002XLS operators will give you many years of reliable service. Please read the
following information to ensure you have the correct system for your particular needs. This manual
will enable you to properly install your 2002XLS Automatic Gate Operators.
The 2002XLS operators are designed for installation on a pull-to-open dual leaf gates. The gates
must not exceed 16 feet in length nor weigh more than 500 pounds* (please see Technical
Specifications on page 1). The 2002XLS operators can be used on vinyl, aluminum, chain link, farm
tube, and wrought iron gates.
Use on solid (wood) gates is not recommended. Solid surface
gates have a high resistance to the wind. If the wind is strong enough, the operators will
obstruct, stop, and blow fuses.
The 2002XLS operators accommodates extra transmitters, digital keypads, solar panels, push
buttons, automatic gate locks, and other access control products.
These optional accessories
are noted with the symbol.
The 2002XLS can be installed on push-to-open gates with the addition of two (2) push-to-open brackets
[3471H].
The 2002XLS operators feature
adjustable stall force. This safety feature makes the gate stop
and reverse direction within two seconds when it comes in contact with an obstruction. The “MIN”
setting means the gate will exert the minimum force on an obstruction before it stops and reverses
direction.
The 2002XLS operators also have an
adjustable auto-close feature. It can be set to remain open
from 3 to 120 seconds before automatically closing. Pressing the transmitter button at any time
after the gate fully opens will cause it to close immediately. “OFF” is the factory setting; meaning
the gate will stay open until you press the transmitter button (or keypad, etc.) again.
Please call GTO at (800) 543-GATE [4283] or (850) 575-0176 for more information about our GTO/
ACCESS SYSTEMS professional line of gate operators and accessories. Our Sales Department will
be glad to give you the name and phone number of a GTO/ACCESS SYSTEMS dealer near you.
BEFORE YOU BEGIN TO INSTALL YOUR AUTOMATIC GATE OPERATOR:
Read these instructions carefully and completely to become familiar with all parts
and installation steps. You must read the installation manual for detailed instructions
on gate operator safety and proper use of the gate operator.
24/7 Troubleshooting Wizard: http://support.gtoinc.com
Please Read This First
, LLC
®
GTO Accessories are noted with this symbol in this
Installation Manual. Information about accessories can be
found on page 28 and at www.gtoaccess.com.
