22
LPA 3000XLS/3200XLS Instruction Manual
Program Your Personal Transmitter Setting
All GTO transmitters are set to a standard code at the factory
and are ready to operate your GTO gate operator. For your
safety and security,
we strongly recommend
that you replace
the factory setting with your own personal setting. Follow the
directions below:
NOTE: If you have multiple transmitters, you should adjust all
of them at this time.
[RB741/RB742/RB743].
Step 1
Use a small phillips head screw driver to remove the
transmitter cover.
Step 2
Set the transmitter DIP switches using a small screwdriver.
There are nine (9) transmitter DIP switches (
RB741 only
); each
can be placed in three different positions (+, 0, –). DO NOT set
all the switches in the same position, such as all +, all 0, or all
–. Once the DIP switches have been reset, replace and close
the access cover.
WARNING: No other adjustments should be made inside the
transmitter.
Step 3
Program the new setting into the control board:
A. Press and hold transmitter button.
B. Press and hold the LEARN RMT (Learn Remote) button
on the control board until the alarm sounds.
C. Release transmitter button. The new code is stored in
control board memory.
D. Release the LEARN RMT (Learn Remote) button.
NOTE: If you have purchased additional transmitters, program
the settings for all at this time.
Step 4
AT THIS POINT YOU SHOULD TEST RECEIVER RANGE
BEFORE PERMANENTLY INSTALLING IT.
+
0
ECE
1 2 3 4 5 6 7 8 9
1 2 3 4
ON
DIP
STATUS
LEARN RMT
LEARN
MAST LIMIT
LEARN
2ND LIMIT
S3
S4
S2
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN
MAX
AUTO CLOSE TIME
STALL FORCE
Learn Remote
Button
1
2
3
4
5
6
7
8
9
EC
E
A23S 12V
ALK
ALIN
E B
ATT
ER
Y
+
0
–
LED
24/7 Troubleshooting Wizard: http://
support.gtoinc.com
The Troubleshooting Wizard has
detailed information this and other
Installations.
