iv
rev 12.14.15
1.
READ AND FOLLOW ALL
INSTRUCTIONS.
Failure to meet the
requirements set forth in the instruction manual
could cause severe injury or death, for which the
manufacturer cannot be held responsible.
2. When designing a system that will be entered from
a highway or main thoroughfare, make sure the
system is placed far enough from the road to prevent
traffic congestion.
3. The gate must be installed in a location that
provides adequate clearance between it and adjacent
structures when opening and closing to reduce the
risk of entrapment. Swinging gates
must not
open
into public access areas.
4. The gate and gate opener installation
must
comply with any applicable local codes.
I. Before Installation
1. Verify this opener is proper for the type and size of
gate, its frequency of use and proper class
rating.
2. Make sure the gate has been properly installed and
swings freely in both directions. Repair or replace all
worn or damaged gate hardware prior to installation.
A freely moving gate will require less force to oper-
ate and will enhance the performance of the opener
and safety devices used with the system
3. Review the operation of the system to become
familiar with its safety features. Understand how to
disconnect the opener for manual gate
operations
(see page iii).
4. This gate opener is intended for
vehicular gates
ONLY.
A seperate entrance or gate must be
installed for pedestrian use
(see page viii)
.
5. Always keep people and objects away from the
gate and its area of travel.
NO ONE SHOULD
CROSS THE PATH OF A MOVING GATE.
6. Pay close attention to the diagram below and be
aware of these areas at all times.
For the Consumer
WARNING: To reduce the risk of injury or death:
Gate in the
Open Position
ZONE 2
ZONE 3
ZONE 4
ZONE 5
Driveway
ZONE 1
Entrapment
Zones for a
Pull-To-Open
Application
IMPORTANT SAFETY INSTRUCTIONS
Summary of Contents for Mighty Mule FM200
Page 35: ...Notes NOTES...
