GTO®, GTO/PRO®, Bulldog®, Mighty Mule® and E-Z Gate® are registered trademarks of GTO, Inc. Professional Access Systems™ , America's DIY Automatic Gate Openers™ are trademarks of GTO, Inc.
and are the exclusive property of GTO, Inc. (“GTO”). All rights are reserved by GTO, and these marks may not be used, in any for without the prior, written permission of GTO. Copyright 2007 rev-11-2007
www.gtopro.com
ESTATE
RESIDENTIAL
PROSL1/2B-CS
AGRICULTURAL
PRO-SL2000B
PRO-SL2000B/PRO-SL1000B
DRIVE
Powered by:
a reliable 12 Volt (120 Watt)
DC motor, case hardened steel gear reducer.
Temperature rating:
-5° F (-28° C ) to
+160° F ( 93° C)
Opening time:
1 foot (.31 m) per second.
Friction disk brake/lock:
designed to
prevent forced entry on models:
PRO-SL1000B and PRO-SL2000B.
POWER
The PRO-SL2000B/1000B series are powered
by one 12 Volt DC / 7.0 amp hour, sealed,
rechargeable battery (included). Battery
charge is maintained by a120V AC/60
Htz input and 18V AC at 40 VA. output
transformer rectified, to 14V DC through
control board. Large battery
(FP295)
recom-
mend in higher cycle or solar applications.
FEATURES
• Full systems capable “add on ready” heavy-duty control board
includes adjustable obstruction sensing, gate sequencing and
auto close settings (0-120 seconds).
• Includes a built-in internal friction disk brake/lock
• Small footprint for tight spaces.
• Easy to install 4’ (1.2m) long post mount provided.
• Chain disconnect for manual operation.
• Light professional and residential cycle rated to 100 cycles daily
• UL rated for Class I, II, & III. System certified to be
in compliance with UL 325, 5th edition.
CONTROLS
• The GTO/PRO® control board can be programmed for
for left-to-right or right-to-left opening.
• Adjustable auto close, obstruction sensitivity and dual gate
sequencing.
• One button auto-memorization of digital transmitter code.
• Charging regulated circuit on control board. “Sleep draw”
is 40 mA; “active draw” is 2 to 9 amps.
• GTO/PRO® remote-mounted 318 MHz RF receiver and one
button transmitter. Included
• Fully compatible accessory terminal block provides
connections for safety loops, wands, intercoms, card
readers, phone systems.
OPTIONS:
Solar Panel Charger:
float voltage 14.5 V DC output from a
19-3/8” (49.21 cm) x 15 1/4” (38.74 cm) silicon alloy panel. Gener
-
ates minimum of 10 watts at 600 mA. A gated diode on the control
board prevents battery discharge. (FM123, FP295 recommened)
PRO-SL1000 and PRO-SL2000
without friction disk brake
lock, operator gear reducer may be back driven.
Concrete mounting pad: SGMP
Dual Gates (master/slave):
PRO-SL1000B/SL1200B or PRO-SL2000B/SL2200B
PRO-SL1000/SL1200 or PRO-SL2000/SL2200
The GTO/PRO PRO-SL2000B series will handle gates weighing up to 1000 lbs. (453.6 kg) and
30 ft. (9.1 m) in length with a 20 ft. (6.1 m) opening; [PRO-SL1000B 500 lbs (226.8 kg)],
if all proper
installation procedures have been followed.
Note: ball bearing rollers should be used on all gates.
Access ready package includes battery backup,
radio receiver, entry transmitter, AC transformer,
and all necessary mounting hardware for a
standard post mount slide gate installation.
SUGGESTED ACCESSORIES:
• Large 26 AmpHr Battery Kit
(FP295)
• Estate Intercom/Keypad
(F4100MBC)
• Gooseneck Pedestal
(F100/F110)
• Driveway Exit Wands
(FM139/FM140)
• Solar Panel
(FM122/FM123)
• Transmitters
(RB741/RB742)
• Digital Keypad
(F310)
• Loop Detector
(LOOPDT1)
• Preformed Loops
(L-SC-0408/0612,
L-PO-0408/0612)
