14
Determining the Mounting Position
of the Post Bracket Assembly and the Gate Bracket
Step 5
With the gate in the open position (up to 110º from its closed position) and the operator fully retracted, adjust the
post bracket assembly and gate bracket until the operator is level. While holding the operator level, use C-clamps to
temporarily
keep the post bracket assembly and gate bracket in their respective positions on the fence post and gate.
Step 4
Attach post bracket assembly and gate bracket to the operator with the clevis pins and bushings. Secure the clevis pins with
hairpin clips.
3/8" x 2" Bolt
3/8" Nut
Post Pivot Bracket
Post Bracket
Post Bracket
3/8" Lock Washer
Post Bracket Assembly
3/8" Washer
NOTE:
The following steps are
intended for
pull-to-open
gate
installations. If you are mounting
your
operators on a
push-to-open
gate
(
e.g., a gate on a sloped
driveway) you will need to purchase
two
Push To Open brackets
(
see
Accessory
catalog
). Also, see
Push-
to-Open Installation
beginning on
page 33.
Clevis Pin
Hairpin Clip
Post Bracket Assembly
Bushing
Rear Mount
Operator
Clevis Pin
Hairpin Clip
Gate Bracket
Front Mount
Bushing
Level Operator
Fence Post
Gate In Open Position
LEVEL horizontal cross member
Post Bracket Assembly
Gate Bracket
Step 3
Insert the
3
/
8
" x 2" bolt through
the center hole of the post
brackets and post pivot bracket
as shown. Fasten a
3
/
8
" lock
washer,
3
/
8
" washer and
3
/
8
" nut
on the end of the bolt. DO NOT
overtighten
the nut because the
post pivot bracket will have to be
adjusted later.
