22
OPTIONAL Solar Panel and Gate Activity
Powering the System
Installation of the Transformer
IMPORTANT:
•
The transformer is designed and intended for indoor use. If the transformer can be plugged only into
an outside electrical outlet, a weatherproof cover or housing (available at local electrical supply stores)
must
be used.
•
All low voltage wire used with the GTO/PRO® 300/3200
®
Gate Operator must be 16 gauge dual
conductor, multi-stranded, direct burial wire (
see page 23
and the
Accessory Catalog
).
Do not run
more than 1000 feet of wire.
•
If your gate is more than 1000 ft. from an ac power source, you will need to use from 10 to 30 watts
of solar charging power to charge the battery (see
Accessory Catalog
). Refer to the
Solar Panel and
Gate Activity
chart below.
Step 1
Make sure the power switch is
OFF
before proceeding to the next step.
Step 2
Select the electrical outlet into which you will plug the transformer.
Measure the distance from this outlet to the control box following the
path where the wire will be laid. After you have measured how much
wire is needed, cut the wire to the appropriate length. (Not more than a
1,000 feet).
ON/OFF Switch
ON/OFF
The table and map illustrate
the maximum number of
gate cycles to expect per day
in a particular area when
using from 10 to 30 watts of
solar charging power. (
see
Accessory Catalog
). The
figures shown are for winter
(minimum sunlight) and do not account for
the use of any accessory items.
Accessories
connected to your system will draw
additional power from the battery.
NOTE
: A maximum of 30 watts of
solar charging power can be connected
to the GTO/PRO® 3000/3200 Gate
Opener. Consult
Solar Panel
Installation
Instructions for further information
.
Winter Ratings
Zone 1 Zone 2
Zone 3
12 v dual gate (10 watts) solar charger
8
16
26
12 v dual gate (15 watts) solar charger
11
20
30
12 v dual gate (20 watts) solar charger
14
28
38
12 v dual gate (25 watts) solar charger
17
36
46
12 v dual gate (30 watts) solar charger
20
44
54
