8
AUTOMATIC GATE OPENER
®
Lock Board
12 Volt Battery
Strain Relief
Double Spade
Tongue Terminals
Wire Connector
Black Operator Lead and White Lock Lead for Pull-To-Open
Opener
Control
Board
RE
D &
BLACK PAIR FROM LOCK
(Retail)
BLAC
K
RED
R
E
D
B
L
A
C
K
BL
A
C
K
B
L
A
C
K
W
H
IT
E
NOTE:
If the gate opens
away from
the property (
push-to-open
) place the
RED
wire from the opener power
cable inside the “through” channel on the Wire Connector. Crimp the Wire Connector closed with pliers
and fold plastic locking tab into place until it locks shut.
If this is a dual gate installation, use the
RED
(push-to-open) or
BLACK
(pull-to-open) wire from the
MASTER GATE OPENER that extends from the power cable to the opener.
Step 5.
Pull
RED
and
BLACK
wires from gate lock through the strain relief and into the control box. Attach
BLACK
wire to Terminal
#3
on lock board. Attach
RED
wire to Terminal
#4
on lock board (
see Wiring
Chart on page 7
).
Step 6.
Attach
RED
lock board battery lead wire to the double spade tongue terminal with the
RED
control
board lead wire. Attach the
BLACK
lock board battery lead wire to the double spade tongue connector
with the
BLACK
control board Lead Wire.
Step 7.
Reconnect opener to gate bracket. Connect
RED
wires (with double spade tongue terminal) to
POSITIVE (+)
battery terminal and the
BLACK
wires (with double spade tongue terminal) to the
NEGATIVE (–)
battery terminal. Plug the transformer in and turn the control box power switch
ON
.
Test opener and lock to make sure it functions properly and make adjustments if necessary.
SERIES
Lock Board
12 Volt Battery
Strain Relief
Double Spade
Tongue Terminals
Opener
Control
Board
RE
D &
BLACK PAIR FROM LOCK
B
L
A
C
K
BLA
C
K
(PRO)
Wire Connector
Red Operator Lead and White Lock lead for push-to-open
Black Operator Lead and White Lock lead for pull-to-open (shown)
BLAC
K
RED
W
H
IT
E
R
E
D
B
L
A
C
K
