CZH-10A. (input power interface).
4.3.5mm plug for two-channel audio cable insert into the
connector 2 of CZH-10A, (R/L Line input), the other side
connect to the appropriate source.
5.If necessary, you can choose to use MIC. They are the
same plug between MIC and audio cable, also 3.5mm
standard. Insert the plug into connector 1(Microphone
connector, Microphone Interface). Note: MIC can only be
electrets MIC, which is the kind of computer voice chatting
generic MIC. Do not support other types, such as
moving-coil microphone installed.
6.Installation finished.
Turn on/off
After installation, check it again carefully then you can
switch on the power. Note: You’d better test the antenna
VSWR before you turn on the machine and make sure it is a
good antenna. Select a standing wave ratio of the minimum
frequency, don’t adjust the frequency any more once you
confirm the frequency. Because as frequency changed, the
antenna will be in a mismatch state. And once the standing
wave is too big, it will burn out the power amplifier if