12
!
WARNING
To prevent SERIOUS INJURY or DEATH from electrocution:
- Disconnect power cord before installing/replacing light bulb.
To prevent possible OVERHEATING or damage to Opener:
- Use ONLY A19 (E26) incandescent bulbs (100W max.).
- DO NOT use short neck or specialty light bulbs.
- DO NOT use halogen bulbs.
To attach the Emergency Release Knob:
1. Thread one end of the rope through the hole of the
Emergency Release Knob and secure with an overhand
knot.
2.
Thread the other end of the rope through the hole in the
Trolley lever.
3.
Measure the rope length so that the knob is 6 feet (183cm)
above the floor and is clear from the top of your vehicle.
Secure with a overhand knot.
Fig. 1
Fig. 2
!
WARNING
To prevent SERIOUS INJURY or DEATH from a falling garage door:
- In case of power failure or door obstruction, PULL EMERGENCY HANDLE to release door from
Opener.
- When Emergency Release is in the released position, the door can be operated manually.
- To reconnect, flip the lever on the Trolley towards Opener, back to Connect position, it will reconnect
automatically upon pressing Push Button or remote control.
- DO NOT use Emergency handle to pull the door open or closed.
Installing Light and Emergency Release Knob
6 feet (1.83m) above floor
Lever
Emergency Release Knob
100W
MAX
To install the lights:
1.
Pull the Lamp Dome from the top and detach it from the
Opener.
2.
Install a standard A19 (E26) 100 watt maximum light bulb.
3.
Re-attach the Lamp Dome.
4.
Repeat steps for second Lamp Dome.
Notice
When replacing the light bulb, make sure the bulb on the Opener
has cooled down to prevent injury.
