Figure 1
A
B
Figure 2
Figure 5
Figure 3
ASSEMBLY
:
1. Remove contents from box.
2. Lay transfer bench upside down
on a flat surface.
3. Attach leg with the large suction
cup (marked “A”) by depressing
the pushbutton and inserting
into the receptacle tube marked
“A” until the pushbutton snaps
and locks into place. Repeat for
second leg (Figure 1).
4. Attach leg with small rubber tip
(marked "B") by depressing
the pushbutton and inserting
into the receptacle tube marked
"B" until the pushbutton snaps
and locks into place. Repeat for
second leg (Figure 2).
5. Turn transfer bench right-side-up.
Depress armrest pushbuttons and
slide into the armrest receptacle
tubes with armrest arching
outwards.(Figure 3).
6. To assemble backrest, insert
pole into backrest support by
depressing pushbutton and sliding
into receptacle tube until it locks
into place. Repeat for second pole
(Figure 4).
7. Insert backrest into base by depressing pushbuttons
and sliding supports through both receptacle tubes.
CAUTION:
Backrest must be locked and secured in
each receptacle tube. (Figure 5).
NOTE:
Back support is reversible to accommodate left or
right tub entry. You can also change the seat depth of your
transfer bench by pushing the pins under the seat and
sliding the tubes forward until the pins lock into place.
G3-100KBX1 G3-100KBPX1 G3-200KBX1 G3-100KBX2 G3-100KBPX2 G3-200KBX2 (PIC-00303)
Revised: 06/23/21
Figure 4
