MDS86800XW (PIC-00311)
Revised: 08/31/18
7
13. Insert the round hand screws (J). Make sure the threaded portion of the round hand screw is
underneath the bolt in the side of the insert (Fig 13).
14. Take the adjustable handlebar (B) that is attached to the rear wheel just installed in step 9
and insert it into the handlebar receptacle on the same side as the wheel is (Fig 14). The
brake cable should be on the outside of the rollator, running down along the rear leg. Align
1 of the holes in the handlebar to the hole in the frame. Insert the triangle knob screw (K),
HAND TIGHT ONLY (Fig 15).
15. Attach the cable to the cable clip on the rear leg (Fig 16). Extra length in brake cable should
loop towards the front of the rollator (Fig 17).
Fig 13
Fig 14 Fig 15
Fig 16 Fig 17
