-6-
1.
Charging the battery
The LED indication ( C ) flashes red and you will hear a sound notification when the battery is in need of
power. We recommend you to stop immediately with driving the Wheeler and charge the battery. When the
battery is almost empty, it is possible that there is insufficient energy to drive normally.
The device will lift
up the chassis during the driving to prevent you from driving it.
If you keep on driving, you can fall much
faster and this can also compromise the future use of the battery.
To charge the battery, make sure that the charging port and the charging surroundings are dry.
Insert the charger in a power socket (100 ~240V), wait for the green LED to light up and insert the battery
charger into the charging port on your Wheeler.
The device is properly charging when the LED on the battery charger is red. If the Wheeler is active, the orange
LEDs on top of the Wheeler will light up for 10 minutes. If this is not the case, repeat the previous steps.
The battery is fully charged when the LED on the battery charger goes from red to green. To guarantee safety,
the battery will stop charging. Charging takes about 2.5h maximum. Remove the connection between the
Wheeler and the charger first, secondly the connection between the charger and the power socket.
Note: While charging the battery it is normal that the adapter feels warm.
Lithium-Ion Battery Pack by LG CHEM 4400mAh
Charging Time
2.5 h
Voltage
36 V
Temperature Range
-10°C ~ 40°C
Temperature Range (while charging)
0°C ~ 40°C
Humidity (when stored)
5% ~ 95 %
<!> WARNING <!>
Only charge the wheeler during daytime or when you can attend the charging. Make sure that you do no
to overcharge the battery. This can strongly influence the lifespan of your battery and in extreme cases
might lead to defects. The lifespan of the battery will decrease after intense usage, this is normal and is
not a defect.
Do not use the Wheeler anymore when it feels exceptionally warm, secretes a scent or when there is fluid
leaking. You are urged to only use a Guardo battery-pack in the Wheeler, like the included battery, made with
original LG CORE cells with extra protection.
Familiarize yourself with the laws for usage, transportation and recycling of Lithium-Ion batteries.
NOTE: You can optionally obtain extra, easy to replace batteries (e.g. for long distances) on www.guardo.be
2.
Using the remote control
The Guardo Wheeler BW650 comes with a remote with wich you can turn the device ON/OFF. You can use
the remote control up to 10m from the device because of the Radio frequency.
To turn the device ON, press: UNLOCK (K)
To lock the device, press: LOCK (J)
You can also set the Speed mode on the remote control. For beginners or children, you can decrease the
reaction-intensity in curves by shortly pressing the Speedmode-button (M). When you start or restart the
Wheeler, the Speed mode is automatically again set for advanced speed and sensitive reaction for curves.
Press (L) to hear a warning signal and to alert other drivers, pedestrians, etc.
