23
D
D
tioning of electric tools could be affected. Have any
damaged parts repaired before using the machine.
Many accidents are caused by poorly maintained power
tools.
f)
Keep cutting tools sharp and clean.
Properly maintai-
ned cutting tools with sharp cutting edges are less likely
to bind and are easier to control.
g)
Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed.
Use of the power tool for operations dif-
ferent from those intended could result in a hazardous
situation.
5) Using and treatment of cordless tools.
a)
Charge the batteries only in chargers recommended
by the manufacturer.
Risk of fire for a charger suitable
only for a certain type of batteries or, as appropriate,
accumulators, if used for other accumulators.
b)
Use only such accumulators in this electric appliance
that have been designed for this appliance.
Use of
other accumulators may lead to injuries and risk of fire.
c)
Do not leave an accumulator not being used near
office clips, coins, keys, nails, screws or other small
metal items that could cause contact bridging.
Short
circuit between accumulator contacts may result in
burns or fire.
d)
Liquid may leak from an accumulator if used impro-
perly. Prevent contact with such liquid. Rinse an
affected body part with water in case of accidental
contact. If liquid gets to your eye, seek medical
advice.
Liquid leaking from a battery may cause skin
irritation or burns.
6) Service
a)
Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This
will ensure that the safety of the power tool is maintai-
ned.
Tacker safety warnings
1. Always assume that the tool contains fasteners. Careless
handling of the tacker can result in unexpected firing of
fasteners and personal injury.
2. Do not point the tool towards yourself or anyone nearby.
Unexpected triggering will discharge the fastener causing
an injury.
3. Do not actuate the tool unless the tool is placed firmly
against the workpiece. If the tool is not in contact with the
workpiece, the fastener may be deflected away from your
target.
4. Do not use this tacker for fastening electrical cables. It
is not designed for electric cable installation and may
damage the insulation of electric cables thereby causing
electric shock or fire hazards.
ENGLISH
EN
Summary of Contents for 58497
