31
GB
Failure removal
Failures
Causes
Removal
The motor does not start.
Closed fuel tap
Make sure the fuel tap and On/Off are in
the „ON“ position
Lack of fuel
Add some fuel
Weak tension on the starter
Pull strongly the starting cord.
Wrong fuel, storing without petrol tank
being drained
Drain the fuel tank and carburettor, add
fresh petrol
Sooted spark plug (carbon residues on
electrodes), electrodes distance too big
Clean the spark plug, check the plug ther-
mal value, possibly change the plug, set
the electrodes distance to 0.6-0.7 mm
The spark plug is wet from petrol (over-
saturated engine).
Dry the spark plug out and refi t it.
Little oil in the engine
Add oil
Unit is not in a horizontal position. Lack
of oil being signalled
Place the unit in a horizontal position
Choke has not been used
Use the choke
8
Engine running irre-
gularly
Too small appliance
Problem with ignition
Make sure the spark plug is fi tted pro-
perly. Make sure the spark plug cable is
on the spark plug. Clean the spark plug
and check the electrodes if correct.
Wrong fuel (propellant)
Make sure proper fuel has been used.
Unit not producing any
current.
Short circuit
Broken cable
Loose cable
Indicator is off :
An error that you can remove yourself.
Contact the GÜDE service centre.
Indicator is on:
1. Press the overloading protection for
the used output.
2. Check the cables.
3. Check for a short circuit or overloa-
ding.
Engine stopping
The Starting current is too big.
Reduce the appliance
Too long cable
Shorten the cable
E-starting not working
Empty or defective battery
Charge or replace the battery
ENGLISH
Summary of Contents for 40643
Page 106: ...102 ...
Page 107: ...103 ...
