10
Expert Net Control 2312
Device Description
or
·
Remove and connect the power supply without operating a button
by Software:
·
Start GBL_Conf.exe
·
Do a network search with the "Search" menu action
·
In menu "Program Device" activate the item "Enter Firmware"
Factory Reset
If the device is in bootloader mode, it can always be put back to its factory default. All TCP / IP set-
tings are reset in this operation.
via push button:
·
Activate the Bootloader Mode of the device
·
Hold down the button (or the "Select" button for devices with 2 buttons) for 6 seconds. If the push
button is recessed, use a pin or paper clip
·
The status LED will blink in a fast rhythm, please wait until the LED blinks slowly (about 5 seconds)
by Software:
·
Activate the Bootloader Mode of the device
·
Start GBL_Conf.exe
·
In menu "Program Device" activate the item "Reset to Fab Settings"
·
The status LED will blink in a fast rhythm, please wait until the LED blinks slowly (about 5 seconds)
Firmware-Update
1.9
To perform a firmware update, the program GBL_Conf.exe and the latest firmware is needed.
Enable the bootloader mode (see Chapter Bootloader Mode)
Start GBL_Conf.exe
Select the device for which a firmware update is to be performed
Click "Program Device" and then select there "Firmware Update"
Specify the firmware file that should be uploaded
Upon completion of the update process, please start the new firmware of the device. You can do this
by simply leaving the bootloader mode.
A firmware update, unlike other functions, is not sent as a network broadcast. Therefore, the device
must have a valid IP address and a valid netmask before the firmware update. If necessary, please
correct the entries in GBL_Conf.exe in bootloader mode and save them with "Save Config".
If after a firmware update, the web page is not displayed correctly anymore, this may be related to the
interaction of Javascript with an outdated browser cache. Not always helps a Ctrl-F5, it is recommen-
ded that you manually delete the cache in the browser options. Alternatively, you can test start the
browser in "private mode".
