4
Operation
4.1
Setting the lubrication cycle / lubrication
quantity
The following table shows the lubricant consumption when standard settings
are used.
You can find additional settings in the third-party documentation from
MEMOLUB.
4.1.1
Lubrication quantity
Lubrication quan-
tity
Per pulse, the lubricant dispenser discharges the following lubrication quantity
to the progressive distributor:
Lubrication quantity [ml]
Lubrication quantity per output
on the progressive distributor
[ml]
0.635
0.1015 (on a progressive distributor
with six outputs)
Table 4-1
Lubrication quantity per pulse: at the lubricant dispenser / at an output of the progressive distributor
The lubrication quantity per output on the progressive distributor is usually
equal. However, closing an output affects the lubrication quantity per output.
Lubrication quan-
tity: Calculation
example
The lubrication quantity is increased by increasing the number of pulses sent
to the MEMOLUB lubrication system. The more pulses are sent within the
same period, the higher are the lubrication quantity and the lubrication con-
sumption.
0.635 ml
1.27 ml
1.905 ml
Fig. 4-1
Calculation example: Lubrication quantity at the lubricant dispenser
Operation
SERVICE MANUAL Automatic lubrication system
Memolub PLCD (24 V DC)
9007199348992139_v2.0_
EN-US
21
