User Manual
23
•
Insert a fully charged battery with the charge terminals pointing inwards and slide in the
battery until you hear a clear sound given by the release button to ensure the battery has
been locked into place.
•
The battery level is displayed in the status display screen at the back of the camera. When
it is to be used up (i.e. the camera will automatically switch off in 15 minutes), an audible
sound alarm will activate and the battery level symbol in the status display screen will
flicker. At this point the battery needs to be replaced by a fully charged one.
•
Before replacing the battery, ensure that the camera is powered off.
•
To remove the battery, open the battery door, keep the battery depressed and then press
the pop-up button. Keep the pop-up button depressed, release the battery, then the
battery will bounce and you can pull it from the camera. When pulling the battery, please
still keep the pop-up button depressed.
•
Replace a fully charged battery as above instructed.
Notes for the battery:
•
Do slide the battery into the battery chamber until you hear a clear sound given by the
release button. Otherwise, the battery is not locked into place and the camera cannot work
well because of unstable power supply.
•
When pulling the battery out of the camera, please ensure the pop-up button is depressed
till the battery finally offs the camera.
•
In the interim of replacing the battery, AC adapter can be connected to the camera without
powering off the camera. Then the AC adapter starts supplying power for the camera and
you can replace the battery with a fully charged one without powering off the camera. After
replacement, you can disconnect the AC adapter from the camera.
