User Manual
91
y
Function is the same as button F4 on the camera:
y
When there is no menu or dialog box in live thermal image, press it to enable the auto
focusing of visual camera.
Troubleshooting
The camera does not turn on
Battery improperly installed (i..e battery is not locked in
place). Remove battery and install correctly.
Battery contacts are dirty. Clean battery contacts.
Battery charge is low. Recharge battery or replace with
fully charged item.
Battery performance is poor
Battery may be defective. Replace battery.
Image is blurry
The target is not in focus. Adjust focus.
Brightness and contrast are inappropriate. Adjust Tmin
and Tmax.
Visual image is blurry
The target is not in focus. Adjust focus of the visual
camera.
Image contrast is low or there is
no image
Temperature set points Tmin and Tmax are
inappropriate. Change the lower set point and upper set
point to values that are more consistent with target
temperatures.
Emissivity setting is incorrect. This affects the
temperature range set points. Check and amend the
emissivity setting.
The lens cap is on. Remove lens cap.
Condensation on camera lens. Place camera in a dry
area at room temperature until condensation evaporates.
