12
System set up
Make sure batteries a charged. One battery at time can be changed even if the unit is on.
Assemble the two antenna bars, with
2 black screws for each bar
underneath the control unit.
Assemble the antenna tubes to the
bars and connect to the control unit.
Note: Tx has one connector and Rx
two connectors. The Rx is marked
with This side up.
The two antenna tubes assembled and connected to
the radar unit.
Connect the DPGS antenna. Attach the
antenna on top of the drone for best
reception.
Attach the MALÅ GeoDrone 80 to the
drone. To prevent damage to the
equipment, make sure the MALÅ
GeoDrone is securely attached prior
to flight and do not use the
GeoDrone as landing gear.
Please contact Guideline Geo for help
on constructing a secure attachment
of the equipment, and information
on Extended Warranty if needed.
Ready to power up the MALÅ
GeoDrone 80 and the GX Controller!
Note: The weight of the GPR system will affect the flight characteristics.
Note: Land the drone smooth and care-fully so you do not harm the equipment.
