Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: service@feiyu-tech.com
Page 2
Because the Data Radio via USB-TTL data cable to power on, the Data Radio will immediately
into work state when it power on, so the antenna should be installed before the USB-TTL data cable
connected to the computer, in order to avoid Data Radio frequency power amplifier circuit part overheat
and burn out.
After the wires connection is OK, USB-TTL data cable connected to the computer USB port, and
through the "device manager" to confirm the current use of serial number, open the "RF_Module_Soft.
Exe" software, click on “COM(P)”:
In the pop-up window, select the right COM and baud rate: 19200,like the picture below shows:
If serial open failed, please check the serial number is correct or not. If the serial number is correct,
please re-plugged the USB-TTL data cable. When serial port is open, please click on the 'Search(S)
