Guilin Feiyu Electronic Technology Co.,Ltd
Guilin Feiyu Electronic Technology Co.,Ltd http://www.feiyudz.cn Tel:0773-5815749
17
immediately and circled over here.
Special Flight Mode Description:
There are three kinds of special flight modes: return, circle, automatic take-off.
Both returning and circling function are determined by PWM pulse width time of CH6’s
output. Corresponds to three gears of the three-step switch on the remote control.CH6 is preferably
in idle mode when the autopilot’s power on. That is switch the three-step switch to the middle
，
correspond to the “Empty” mode.
PWM pulse width
time of CH6
1000-1199
μ
S 1200-1800
μ
S 1801-2000
μ
S
Function Return Empty
Circle
Return:
No matter in what’s mode , once switch it to return mode ,the plane will immediately
considering the home point as the target point, implementing the return process, and circling after
reach the home points.
Circle
: No matter in which mode, once switch it to circle mode, the plane will immediately
considering the current point as the central point, implement the circle process.
The
circle radius is
determined by the circle radius you have set (The default value of the circle radius is 100 meters
once the power on).
Automatic Take-off:
Please switch to this mode by use GCS software. The priority level of the
auto take off task is higher than other tasks, press “cancel”
button to cancel after switch
to auto take off procedure. When its implement auto take off procedure, the plane will automatic
climbs to 50 meters high, keep horizontally flying, and then decide the next task according to the
current switch state of the CH5 and CH6.
Automatic Photo:
The default is off, once turn it on, it will turn to green.
The autopilots will
automatic control the camera interface and implement level action to take photos according to the
setting photo distance.
Photo:
Click to take a picture immediately and the camera
interface implement level action once .The camera interface is I/O
level control, so through set camera reverse to decide the high level
or low level when taking a photograph .I/O port can use to drive
the relay ,or control the camera directly which support by the level.
RC Receiver:
The default is turn on, when you turn off the RC
receiver, the manual remote control will turn off .But you still can
operate it by GCS software.
Heading Cycle:
The default is open, if you turn on it during air
route flying, the plane will not circling when get to the last point, it
will circled according to the ordered way point. If you turn on the
air route circling after the fly start circling, the fly will not start circle flying, you have to exit
automatic navigation mode, and switch it to air route flying ,then
it will start air route flying .
Pointing Flight:
After implement auto navigation ,please click
this button in mode “pointing flight”, you can implement it on
the map.
Parachute Opening:
Click the parachute opening button once,
the parachute opening servo will act once .
