Guilin Feiyu Electronic Technology Co.,Ltd
Guilin Feiyu Electronic Technology Co.,Ltd http://www.feiyudz.cn Tel:0773-5815749
19
the auto control servo, suggest to use this mode to take off)
.
2.Switch to “Auto Balance Remote Control” and check whether the flight unusual, operate the
flight and feel whether the autopilot has the auto balance function of automatically correct the
flight to horizontal .Change the flight’s status by manual, for example, rolling, pitching and so on
to observe the flight automatically recovery condition .If it is not very good, just adjust the
“pitching stability” and “rolling stability” coefficient of the auto balance control according to the
circumstance .
As Bellowing :
For Example:
If the amendment result of the flight pitching is not obvious, it need to
increase pitching stability control coefficient .If the flight pitching amendment is over fast and
vibrates, it need to decrease the pitching stability control coefficient.
For Example:
If the amendment result of the flight rolling is not obvious, its need to
increase rolling stability control coefficient .If the flight rolling amendment is over fast and
vibrates its need to decrease the rolling stability control coefficient.
3.After finish to adjust the auto balance control of the flight,
under the auto balance control mode ,adjust the remote controller
fine tune to keep the flight horizontally flight when not operate the
remote controller .(If the remote control neutral position of the
flight straight flying is not same in manual mode and auto balance
mode, then it can adjust the installation angel of the autopilot
measurement module to solve .Notice :just make sure the flight can
straight flying in auto balance mode ,the deviation of the neutral
value will not influence the result of auto navigation in manual
mode and auto balance mode.)
4.After straight flying in auto balance mode, keep cruise throttle. Do not operate the remote
controller, acquisition servo neutral value.
5.After acquisition servo neutral value, observe the flight without unusual, help the flight
climb to the altitude which as high as the setting route altitude. Then switch into "automatic
navigation mode ",observing the auto navigation flying condition of the aircraft through the ground
station software and visual ,then adjustaccording to actual
conditions.
6.Adjustment of the turning control .For Example: The flight
fly from A point to B point and then to C point.
A
B
C
C
A
B
Increase Aileron Control
Coefficient
C
A
B
Reduced Aileron
control coefficient
