P4
Remove 3pcs of motor stoppers.
Attach the blade assembly to motor using
motor screws from hardware bag firmly.
10. Blade assembly to motor
13. Turn on the power, your fan is ready for operation.
Motor screw
Blade Assembly
Motor stopper
12.Connect pull chain knob to pull chain.
Pull Chain Knob
*NOTE: Do not bend blade or blade arm to prevent wobble.
Insert wires existing from Light Kit Fitter by passing through center hole and
attach Light Kit Fitter to Switch Housing Cover with threaded tube and /or
fasten with spring washer and hex nut.
11. Make wire connections for light kit
(if this fan equips with light kit)
Terminal Block Style ---- Loosen screws on Terminal
Block first, for accepting new wires from Light Kit.
( 1 ). Insert white wire from Light Kit into terminal block
extending from orange or white wire from fan
and tighten by screw on terminal block.
( 2 ). Insert black wire from Light kit into terminal block
extending from brown or blue wire from fan and
tighten by screw on terminal block.
Attach Light Kit and Switch Housing Cover assembly to
Switch Housing and secure with three original screws.
Terminal Block Style
Switch Housing.
Screw
Switch
Housing
Cover
White or
Orange Wire
White Wire
Light Kit
Fitter
Terminal block
Small Screw Driver
Black Wire
Blue or Brown Wire
