.
1.
To fill water:
Simply fill the water inside the plastic bowl.
CAUTION: DO NOT USE FOAMING, SUDSING OR MINERAL OIL BASED ADDITIVES IN THE WATER.
2. .
To start whirlpool:
Press the jet button as shown. This will start your Clean Jet motor. You may stop the whirlpool function at any time by
pressing the button again.
3.
To drain:
Unlock the footrest and full the footrest forward as shown in Fig.1.
then simply tilt the plastic bowl to drain the water into the drain sink as shown in Fig.2.
4. The Shiatsu Roller back massage Chairs are equipped with a state of-the-art robotic massage system.
This system is easy to use. The remote has a one-touch power button that initiates a pre-programmed massage
session. Various massage functions are also available for selection via this remote. The chair's position can also be
adjusted; forward/backward as well as reclined to the client's preference (see illustrations on page 12).
Note: Read and Follow Chair Manual Instructions
OPERATIONS & USE
11
Control Panel
Jet Control
Discharge Pump Switch
(Optional)
Heat Surface
Drain Sink
Fig.2
Footrest Lock
13
Footrest
Fig.1
BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING:
1. Read and follow all instructions
2.
DANGER
. To reduce the risk of injury, do not permit children to use this unit unless they are supervised
at all times.
3. Use this unit only for its intended use as described in this manual. Do not use attachments that are not
recommended by the manufacturer.
4. Never drop or insert any object into any opening.
5. Do not block jets during whirlpool operation.
6. The unit must be connected to an electrical supply circuit that is protected by a ground fault circuit interrupter.
7. The clean jet motor is magnetically driven and is insulated twice. Therefore it does not require to be bonded.
Save these instructions
