Guntermann & Drunck GmbH
Operating Instructions UserCenter 2 (4)
Page 9
6.6
Darkening of a screen if the hold function is
enabled
With this setting you define whether the screen of a console will be darkened if
another console is active.
To enable darkening proceed as follows:
•
Call up the setup mode with
CTRL
+
BACKSPACE
The setup mode will be indicated by the flashing of the three keyboard
LEDs (NUM-Lock, CAPS-Lock, SCROLL-Lock).
•
For enabling press
V
•
To
disable
the darkening againg press
B
After the darkening is enabled/disabled the setup mode will be closed
automatically. The keyboard LEDs stop flashing.
This setting has direct influence on the manual and automatic hold
function (
see chapters 6.4 and 6.5
)
You can always stop the entry by pressing
ESC
.
6.7
Transmission of GDFrames
A change of this setting should only be done as agreed with the G&D
service.
For transmitting GDFrames proceed as follows:
•
Call up the setup mode with
CTRL
+
BACKSPACE
•
For transmission press
G
•
To
disable
transmission again press
H
After the transmission of GDFrames is enabled/disabled the setup mode will be
closed automatically. The keyboard LEDs stop flashing.
You can always stop the entry by pressing
ESC
.
