Getting started
4.1 Logging in
The default login name is
root
and the default password is
guralp3
. (Older
units had a default password of
rootme
.) Note that the password is not
displayed while you type it.
Note:
The password must be changed if the unit is to be connected
to the Internet. Refer to the Platinum manual, MAN-EAM-0003, for
instructions regarding changing the password.
4.2 Switching on and off
4.2.1 Switching on
To switch on the NAM, connect a mains (line) power cable to the power inlet on
the rear panel. The unit will start immediately.
4.2.2 Switching off
The NAM should be shut down before removing power. This can be done using
the web interface, from the console or from the command line.
4.2.2.1 Switching off using the web interface
To safely shut down the NAM from the web interface, select “Reboot” from the
“Control” menu. Click
on the resulting screen. Wait until the
green front panel power indicator has extinguished before removing power.
4.2.2.2 Switching off using the console or command line
To safely shut down the NAM from the console or command line, enter the
command
poweroff
8
Issue C - March, 2018