USER MANUAL- Termonebulizadora Guskiner 1980'S Fogger Pro
13, The operator must wear labour protection appliance according to the following requirements.(see Figure 3):
A. He must wear working clothes: the work wear must be applicable, wich can not interfere with the action.
Do not wear skirts, coats, scarves, ties and jewerly;
B. He must wear protective gloves.
C. He must wear protective shoes.
D. He must wear safely helmet.
E. He must wear a gas defensive mask.
F. He must wear ear protectors (especeally when working for a long time)
14. When the macine works, nobody is allowed to enter the work area of danger.
15. The machine must be stopped before the operator leaves, It is not allowed to keep the machine running wit
the operator left.
16. In the spraying process, the distance between the nozzle and crops shall be more than 0.5 meters. The
spraying in one direction to he crops shall not be longer than 3 seconds.
17. The pesticide solution should be prepared for immediate consumption, don't doit advance.
18. The treatment of pesticides should comply with the safecty instruccionts provided by the manufacturer.
19, The use of special working fluid is prohibited.
6. Common failures and troubleshooting methods
6-1 Difficult to start-up
1. Ignition needle does not work or high voltage package is damaged.
When the machine is difficult to start, check the test power first to check whether there is squeak sound
when the needle works. If there is no sound, it means that the ignition needle or high voltage package
is damaged. In this case remove the cap on the carburetor first, then remove the ignition needle with
the sleeve, check wheteher there is carbon deposition is found, grind it with sand paper. After grining
finished, reload needle to the machine and check the test power again, If the ignition needle still does
not work, check the battery condition, cables and high voltage package. Before the high voltage
package is checked, remove the cap, place the high voltage cable at a distance of 2mm away from the
machine to test the power and high voltage package. If it is not ignited, check if the cable is loose or
fall off. It the cable is not loose of fall off, replace high voltage package. If the ignition is weak, it shows
the electricity is insufficient, please charge the battery.
2. The diaphragm damage of carburetor.
After a long time operation, if the machine is not easy to start, please check the carburetor diaphragm
assembly and check the diaphragm. if it is damaged, please change it.
Note: when the diaphragm is changed, don't put it into wrong position. Remember the order when you
demolish it and install it in reverse order.
