mega macs 56 Bike
•
>Service reset<
Here you can reset the service interval manually or automatically.
•
>Basic settings<
Here you can assign basic setting values to ECUs and actuators.
•
>Codings<
Here you can code tasks to actuators and ECUs and you can adapt new components to the vehicle.
•
>Test function<
Here the device evaluates and depicts the performance of the individual cylinders.
7.4.1 Preparing Vehicle Diagnostics
The selection of the correct vehicle is a basic precondition for trouble-free vehicle diagnostics. The device provides
various kinds of assistance to facilitate the selection, e.g. indicating the installation position of the diagnostic port.
The following ECU functions are possible in the
>Diagnostics<
menu:
•
Trouble code readout
•
Parameter readout
•
Actuator tests
•
Service reset
•
Basic settings
•
Codings
•
Test function
Proceed as follows to prepare vehicle diagnostics:
1. Perform steps 1 to 10 as described in the section
CAUTION
Rolling of vehicle
Risk of injury or material damage
Proceed as follows before starting:
1. Prevent the vehicle from rolling.
2. No gear is engaged.
3. Regard the window with infos and instructions.
NOTICE
Short circuit and voltage peaks when connecting the DT VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the DT VCI to the vehicle.
2. Insert the DT VCI into the vehicle's diagnostic connector.
Both LEDs of the DT VCI flash. The DT VCI is ready for operation.
3. Select
>Diagnostics<
in the main menu.
Now you can select the type of diagnostics.
63