mega macs 56 Bike
18. Push the button indicated.
The actuator test is performed.
The message
Actuator test successfully done
appears if the actuator test was successful.
7.4.5
Service reset
Use this menu to reset service intervals provided that this function is supported by the vehicle. The device performs
the resets either automatically or you find a description for the manual reset procedure.
7.4.5.1
Performing Manual Service Resets
CAUTION
Rolling of vehicle
Risk of injury or material damage
Proceed as follows before starting:
1. Prevent the vehicle from rolling.
2. No gear is engaged.
3. Regard the window with infos and instructions.
Proceed as follows to perform the manual service reset:
1. Perform steps 1 to 10 as described in the section
NOTICE
Short circuit and voltage peaks when connecting the DT VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the DT VCI to the vehicle.
2. Insert the DT VCI into the vehicle's diagnostic connector.
Both LEDs of the DT VCI flash. The DT VCI is ready for operation.
3. Select
Diagnostics > Function > Service reset
.
NOTE
The selection of the following possibilities depends on the selected manufacturer and vehicle
type:
•
Functions
•
Assemblies
•
Systems
•
Data
4. Select the requested system.
5. Observe the info window.
6. Call up the
>Information<
tab.
7. Follow the instructions on the screen.
8. Start the manual service reset with
.
9. Select the OBD plug in the subsystem where necessary.
10. Regard the window with infos and instructions.
11. Follow the instructions on the screen.
71
