mega macs 56 Bike
Updating the Device, DT VCI and Modules
3. Start
Update
under
Step
with .
The device searches for a new update that will then be downloaded and installed.
The device switches off and on again after the successful system update. The installation will be checked automatically
after startup.
6.2.5
Calling Up DT VCI Information
Here you will find all information required for the identification of the DT VCI.
Proceed as follows to call up DT VCI information:
1. Select
Update
under
> Settings
in the main menu.
2. Select
>DT VCI<
.
An info window appears.
This menu provides the software and hardware version and the module type of the DT VCI.
6.2.6 DT VCI Update
Update the software for the DT VCI here.
6.2.6.1
Starting a DT VCI Update
NOTICE
Insufficient voltage supply
System data loss
Do not switch off the device and the DT VCI during the update and do not disconnect them from
voltage supply.
Ensure sufficient voltage supply.
Proceed as follows to start the DT VCI update:
1. Select
Update
under
> Settings
in the main menu.
2. Select
>DT VCI<
.
CAUTION
Rolling of vehicle
Risk of injury or material damage
Proceed as follows before starting:
1. Prevent the vehicle from rolling.
2. No gear is engaged.
3. Regard the window with infos and instructions.
NOTICE
Short circuit and voltage peaks when connecting the DT VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the DT VCI to the vehicle.
3. Insert the DT VCI into the vehicle's diagnostic connector.
Both LEDs of the DT VCI flash. The DT VCI is ready for operation.
28
