mega macs 56 Bike
8.1.5.3
Zero Reset of Values
Here you can set the following value windows to zero simultaneously:
•
Minimum
•
Maximum
•
Peak-to-peak
Proceed as follows to set the value window to zero while measurement is in progress:
1. Reset the values to zero with
>
.
The selected value windows are set to zero simultaneously.
2. Go one step back with
.
8.1.6 Other Configurations
8.1.6.1
Configuring Indications
Here you can switch on or off the indication of 9 measured variables for describing a signal.
Proceed as follows to set the indication while measurement is in progress:
1. Call up Settings with
.
2. Select
>Indication<
.
3. Activate the check box for the requested measured variables.
A maximum of 8 measured variables can be displayed at the same time.
4. Confirm the selection with
.
The corresponding measured values appear in the left part of the screen.
8.1.6.2
Activating the Expert Mode
Here you can activate expert mode, which is used to enable functions such as the following:
•
Inversion
•
Trigger mode
•
Trigger edge
•
Trigger level
Expert mode is set to
>off<
by default ex works.
Proceed as follows to activate the expert mode while measurement is in progress:
1. Call up Settings with
.
2. Select
>Miscellaneous<
.
3. Open the list under
Expert mode
with
.
4. Select
>on<
.
The expert mode is active.
5. Confirm the selection with
.
90
