mega macs PC
10.3.2 Setting Up the Printer
10.3.2.1 Printing with Standard PC Printer
Here you can set the standard printer for printing with the PC on which the mega macs PC software is installed.
For this, the mega macs PC software must forward the data to be printed to the Hella Gutmann Drivers. Then the
Hella Gutmann Drivers sends the data to the standard printer of the system.
Proceed as follows to print out results with the standard printer:
1. Select
Interfaces
under
> Settings
in the main menu.
2. Select
>Printer<
.
3. Open a list under
Interface
with
.
4. Select
>Gutmann Portal<
.
The selection will be saved automatically.
5. Use
to open the virtual keypad under
top (mm)
.
The margins are set ex works to 15 mm.
6. Delete the number set ex works with
or
where necessary.
7. Enter the requested height of the margins in mm.
8. Confirm your entry with
.
The input will be saved automatically.
9. Repeat steps 5-8 for further entries.
10. Where necessary, activate the check box
Blank out company logo
to print out results without the company logo
of Hella Gutmann.
This function enables hard-copy printouts on printed paper.
Now you can start printing via PC.
10.4
Setting the Country
Configure the following data here:
•
Language setting
•
Country setting
•
Currency
10.4.1 Setting the Language Option
Here you can set the language if the software is multilingual (optional).
Proceed as follows to set the language:
1. Select
Country
under
> Settings
in the main menu.
2. Open the list under
Language setting
with
.
The compilation of languages depends on the prevailing software.
3. Select the requested language.
4. Regard the window with infos and instructions.
5. Close the window with infos and instructions with
.
The mega macs PC software will be finished automatically. The language setting will be saved automatically.
35
