33
Requirements | Assembly instructions | Care information
• Observe the local building regulations and the snow load zones in your region.
• Before the assembly sort the parts and check the contents list according to the assembly instructions.
• At least 2 persons are required to assemble the terrace roof.
• Follow the instructions and installation steps in the assembly instructions.
• The Twin-Wall Sheets do not walk on transverse running boards (at least 2 rafters).
• Point loads must be avoided absolutely
• Regularly remove snow from the roof
• Snow load: models with 3 - 4 m roof depth: 150 kg/m² and models with 5 m roof depth: 100 kg/m²
• Included fixing material is only for solid masonry. Separate fixing materials must be used for insulation, hollow
blocks, etc.
• Keep the gutter free of leaves, dirt and snow.
• The terrace roof must be installed on a flat, solid surface (for example concrete, concrete slabs).
Foundation di-
mensions: length 40cm x width 40cm x depth 80cm
• Clean the Twin-Wall Sheets with water and a mild detergent and do not use abrasives, acetone or solvents!
• Defective or bent posts or beams must be replaced immediately.
• The wall connection profile must be installed at the following height (measured at the upper edge of the
profile)
3m depth: 240cm = 7° - 300cm = 20°
4m depth: 240cm = 5° - 340cm = 20°
5m depth: 245cm = 5° - 375cm = 20°
• As the cross beam can be moved by max. 60cm towards the house wall, this results in a higher roof pitch (slope).
Colour and size deviations etc. within the usual tolerances reserved. Our recommendations do not release the custo-
mer from the obligation to check the product on his own responsibility. In case of doubt, please consult a specialist.
Technical modifications reserved.
T
he Premium Terrace Roof has been developed and manufactured according to EN 1090. It may only be used for
roofing over a terrace with appropriate fastening for the respective house wall and for non-commercial use. Any use
other than the intended use described here is considered improper use. The manufacturer is not liable for any damage
or consequential damage resulting from improper, incorrect or inappropriate use.
13, 17, 19
4 und 5
17
TX 25
