TO BOIL WATER
1. Remove kettle from base.
2. Open the lid until it stands vertically. DO NOT BEND LID
FURTHER BACK!
3. Fill with the desired amount of fresh cold water. The kettle has
minimum and maximum markings. Never underfill or overfill the
kettle.
CAUTION / DANEROUS: Never fill above the MAX line. If you
fill above the max line, boiling water will push out of the pouring
spout. This can cause severe injuries and burns.
4. Close lid.
5. Place kettle on Power Base.
6. Plug cord into wall outlet.
7. Gently push the On switch upwards. The blue Indicator Light
will turn on and the kettle begins to heat the water.
8. When the water comes to a boil the kettle will turn off
automatically, the on-switch will jump down and the light will
shut off.
9. Lift kettle from base and pour water out slowly.
10. Replace kettle.
11. If you want to bring the remaining water to a boil again, repeat
step 7.
HELPFUL HINTS:
• Never try to boil water with the lid open.
• Do not leave water standing in the kettle. Discard unused water.
• If the kettle is „ON“ without water, the kettle will automatically turn
off (the blue indicator light will turn off, but the switch will NOT
jump back). Slide the switch downward to the complete OFF
position.
• If you remove the kettle during heating – before Auto Shut-Off –
the blue indicator light will turn off but the switch will stay in the
ON position. If you place the kettle back on the power base, the
light will turn on again, indicating that heating continues. You can
always slide the switch downward to the complete OFF position.
Summary of Contents for GZ-201
Page 31: ......
