3. Cautions
p
It must be checked that the voltage used should be the same as the rated voltage before the
refrigerator is used.
p
Water contained in food or getting into air inside the refrigerator by opening doors may form a
layer of frost inside, It will weaken the refrigerator when the frost is thick, The refrigerator can
defrost automatically. The defrost water flow into the water collection pan through the drain port
and evaporate by the heat of compressor.
p
If the supply cord of this appliance is damaged, it must only be replaced by a repair shop
appointed by the manufacturer, because special purpose tools are required.
p
It is dangerous to alter the specifications or attempt to modify this products in any way.
p
When you change the light bulb or when the refrigerator is not in use for long periods, disconnect it
from the electricity supply.
p
Wait for 5 minutes before restart the unit after the power supply blackout.
4. Changing the reversible door
Reversing the door
The side at which the door opens can be changed from the right side (as supplied) to the left side, if
the installation site requires.
Warning!
When changing the side at which the door opens, the appliance must not be
connected to the mains. Remove plug from the mains beforehand.
Tilt the appliance slightly towards the rear and prop it
securely. Unscrew the door hinge screws and remove the
hinge pin bracket. Open the door a little way and take it
out downwards.
Unscrew the upper pin and screw it into place on the
opposite side. Fit the door into the upper pin and close it.
Screw the hinge pin bracket side using the screws securely
into place on the opposite.
BOTTOM
WORK
TOP
WORK
