3. Cautions
It must be checked that the voltage used should be the same as the rated voltage before the
refrigerator is used.
Water contained in food or getting into air inside the refrigerator by opening doors may form a
layer of frost inside, It will weaken the refrigerator when the frost is thick, Defrosting on evaporator
is operated manually. When the biggest thickness of the frost layer on the evaporator increase
to 4mm, it must be turn off the power supply to defrost. The defrost water flow into the water
collection pan through the drain port and evaporate by the heat of compressor.
AIf the supply cord of this appliance is damaged, it must only be replaced by a repair shop
appointed by the manufacturer, because special purpose tools are required.
It is dangerous to alter the specifications or attempt to modify this products in anyway.
When you change the light bulb or when the refrigerator is not in use for long periods, disconnect it
from the electricity supply.
Wait for 5 minutes before restart the unit after the power supply blackout.
4. Changing the reversible door
This refrigerator has been built with the door hinges on the right. If you wish to change the opening
direction, follow the instructions below:
1. Remove the upper hinge cover(6) first
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the frame. Take away the
upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws(8) that hold the lower hinge(2) and Make sure to
Remove the lower hinge(2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the hole cover plate(7) to the right side.
7. Before placing this lower hinge(2), remove the bolt-pin (9) and reverse the direction of the lower
hinge(2). Then install the lower hinge (2) onto the left side of the lower frame with two screws (8).
8. Insert the bolt-pin(9) to the lower hinge (2).
9. Set the door to its place making sure the door seat at the lower hinge(2)
10. While holding the door in the closed position secure the upper hinge (5) in the top frame of left
side with two screws (1). Please remember that do not tighten the two screws(1) until the top of
the door is levelled with the counter top.
11. Install the upper hinge cover(6) on the upper hinge.
Summary of Contents for GZ-340
Page 10: ......
