K-BUS
KNX/EIB 3.5/5.0/10.1 inch Touch Panel Plus
17
○
R
4)
The status display of the slider can be updated by rewriting the position status/Slat position status of the bus.
Curtain with 1 Slider-Move Percent
Figure 5.2_5
The touch function page curtain icon will pop up the interface shown in Figure 5.2_5:
1) Sliding slider, the device will send a message with the corresponding object (Blind position) value as the
stroke value every 500ms interval.
2) Click
icon, The device sends a message with a 0% travel object value. Click
icon,The device
sends a message with a target value of 100%.
3) Click
icon,You can return to the function page.
4) The status display of the slider can be updated via the bus over the status of the position (Position status).
5.3 Air Quality Feature Page
Figure 5.3_1
The air quality feature page displays seven parameters, which are:AQI
、
Temperature
、
Humidity
、
PM2.5
、
PM10
、
CO2
、
VOC
。
Note:
Only four of these parameters can be displayed at the same time. The contents of the configuration display
can be configured through the database.
Touch the corresponding entry on the right to display the corresponding parameter values and graphics on the
left. The update of the displayed value can be achieved by overwriting the object via the bus.
