3.2
Display and Initial Settings at Power-on
APS-1102 Programmable AC/DC Power Source
3-5
3.2
Display and Initial Settings at Power-on
Display at power-on
When the power switch is set to on, a fault check is performed automatically, and when that ends
normally operation mode is set.
The settings shown on the panel are those that were shown the last time the power source was turned
off. When a newly purchased unit is turned on for the first time, the initial settings are displayed.
See “4.8 Using Memory Functions”
, for description of how to read settings saved to
memory.
An error message is displayed when an abnormality has occurred. After reading the error message,
turn the power source off immediately.
See “7.2.1 Error at power-on”
, for description of error messages and recommended
responses.
Initial settings
Table 3-1
and
Table 3-2
list the initial settings for the APS-1102.
Table 3-1. Settings in Memory (1/2)
Function
Setting
Initial Setting
At Power-on
Select output mode
Output mode
AC-INT
Backup value
Select output voltage range Output voltage range
100 V
Backup value
Select external sync signal
source
External sync signal source
LINE
Backup value
AC mode output
(AC-INT, AC-ADD,
AC-SYNC)
AC voltage
100 V range
SIN/SQU
0.0 Vrms
Backup value
ARB1 to ARB16
0.0 Vp-p
200 V range
SIN/SQU
0.0 Vrms
ARB1 to ARB16
0.0 Vp-p
AC voltage frequency
50.0 Hz
Phase when output goes on
0.0
AC voltage waveform
Sine wave (SIN)
AC+DC mode output
(AC+DC-INT,
AC+DC-ADD,
AC+DC-SYNC)
DC voltage
100 V range
0.0 V
Backup value
200 V range
0.0 V
AC voltage
100 V range
SIN/SQU
0.0 Vrms
ARB1 to ARB16
0.0 Vp-p
200 V range
SIN/SQU
0.0 Vrms
ARB1 to ARB16
0.0 Vp-p
AC voltage frequency
50.0 Hz
Phase when output goes on
0.0
AC voltage waveform
Sine wave (SIN)
