Ⅷ
.Problem And Resolve
1.How to adjust the focus?
1) The system automatically defaults the cutting material thickness to 3mm. If the
cutting material thickness is 3mm, there is no need to adjust the focus.
2) If the cutting material is of other thickness (within 0-17mm), place the material on
the honeycomb panel, enter the website operation page, and click the blank area above
the Select SVG on the left side of the page (as shown in the green box in Figure 1), in
Focus Height Enter the parameters and click Confirm to complete (refer to Table 1 for focal
length parameters). For example, when the material thickness is 2mm, the Focus Height is
set to 17mm-2mm=15mm. Enter 15mm in Focus Height. Among them, 17mm is a fixed
value, and Focus Height value=17mm-material thickness.
47
4. Clean The Camera
Use a cotton swab dipped in alcohol to
wipe the wide-angle camera on the top
cover of the laser printer.If there are spots
in the middle of the mirror, it cannot be wiped
clean , you need to replace it. Please take
photos and contact us;
5. Clean the protective lens
Dip a cotton swab with alcohol and
gently wipe the protective lens.
Summary of Contents for Desktop 3D Laser Printer
Page 1: ......
Page 22: ...18...
Page 39: ...Click The material selection list pops up Click to calibration camera 35...
