2) Check whether the drawer protection
limit is working properly. When the drawer is
pulled out, the protection limit red light goes out,
the LED light dims, when the drawer is closed,
the protection limit red light turns on, and
the LED light turns on, it is normal operation
(Figure 9)
Figure 9
4.Wifi Can't Connect
When the machine cannot connect to wifi and the web page displays offline(as shown in
Figure 10)
Figure 10
1) Confirm whether the wifi is placed within 3 meters from the machine, and there is
no wall or others blocking the signal.
2) The machine supports 4g hotspots, but not 5g hotspots.
3) If you cannot guarantee that the wifi is within 3 meters of the machine or there is a
wall between the wifi and the machine, you need to purchase a wifi signal booster your-
self (as shown in the picture) and place the signal booster next to the machine.
51
Summary of Contents for Desktop 3D Laser Printer
Page 1: ......
Page 22: ...18...
Page 39: ...Click The material selection list pops up Click to calibration camera 35...
